 |
 |
 |
|
|
|
[Sponsors] | ||||
[snappyHexMesh] snappy does not add layer to whole body |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
October 20, 2016, 11:09
|
snappy does not add layer to whole body
|
#1 |
|
New Member
Lilly
Join Date: May 2014
Posts: 11
Rep Power: 12  |
Dear Foamers,
I had a question concerning snappyHexMesh, but it turned out that the geometry I was given had an unexpected error. Unfortunately it was not visible in snappy, only in another meshing program. So my whole questioning is irrelevant. Last edited by 5tern; October 24, 2016 at 04:37. |
|
|
|
|
|
| Tags |
| layer, snappyhexmesh |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| How to add a fine boundary layer | Jinjolee | OpenFOAM | 0 | April 17, 2019 05:04 |
| [snappyHexMesh] Problem airfoil snappyhexmesh add layer | bye bye my blue | OpenFOAM Meshing & Mesh Conversion | 1 | May 5, 2017 06:56 |
| [PyFoam] and paraview | eelcovv | OpenFOAM Community Contributions | 28 | May 30, 2016 10:23 |
| [snappyHexMesh] SnappyHexMesh: Layer on corners | Pj. | OpenFOAM Meshing & Mesh Conversion | 9 | July 17, 2014 05:26 |
| [snappyHexMesh] snappy Error | dhruv | OpenFOAM Meshing & Mesh Conversion | 2 | June 29, 2012 05:55 |
Linear Mode
