 |
 |
 |
|
|
|
[Sponsors] | ||||
[Other] 3D Mesh of a wind turbine blade. Which tool to use? |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
May 13, 2016, 05:11
|
3D Mesh of a wind turbine blade. Which tool to use?
|
#1 |
|
Member
Join Date: Dec 2015
Posts: 74
Rep Power: 11  |
Hi to everyone.
I would like to create the 3D model of an HAWT blade and then generate a 3D mesh for a further simulation in OpenFOAM. The 3D mesh is composed by a boundary layer(from a surface quad structured mesh), and an external zone of tetra elements. I was exploring Salome in order to create the 3D model, but then? What is the most suitable meshing tool to do a 3D structured-non structured mesh for openFOAM? Thanks, WhiteW |
|
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Wind Turbine blade in 120° wedge - boundary conditions | Fcamp | OpenFOAM Running, Solving & CFD | 1 | December 2, 2019 07:47 |
| Anyone willing to do a "paid" ICEM mesh for a wind turbine blade ! | xXAhmedXx | CFD Freelancers | 3 | October 12, 2017 00:09 |
| Moving mesh | Niklas Wikstrom (Wikstrom) | OpenFOAM Running, Solving & CFD | 122 | June 15, 2014 07:20 |
| Problem in conducting CFD of analysis of wind turbine blade | atulpat | CFX | 16 | August 17, 2013 05:09 |
| Sliding Mesh and Wind Turbine | FJSJ | FLUENT | 1 | June 27, 2013 02:32 |
Linear Mode
