 |
 |
 |
|
|
|
[Sponsors] | ||||
March 31, 2016, 14:02
|
blockMesh: Command not found.
|
#1 |
|
New Member
AW
Join Date: Mar 2016
Posts: 17
Rep Power: 10  |
Hello everyone,
i have at the moment trouble using the command blockMesh by excising the tutorials. The error is:blockMesh: Command not found. I have searched in the internet for a solution for quite a while. But there were actually no suitable solution for me. As advised i checked the file "platforms" and the data "blockMesh" is there. And the command "icoFoam" works without problem in my computer. Can any of you give me some advises to solve this problem? Thank you very much! Best Regards, Andy |
|
|
|
|
 |
| Tags |
| blockmesh not found |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Building OpenFOAM1.7.0 from source | ata | OpenFOAM Installation | 46 | March 6, 2022 14:21 |
| OpenFOAM on cluster: version GLIBCXX_3.4.9 and GLIBCXX_3.4.11 not found | ovie | OpenFOAM | 10 | April 19, 2021 19:06 |
| problem during mpi in server: expected Scalar, found on line 0 the word 'nan' | muth | OpenFOAM Running, Solving & CFD | 3 | August 27, 2018 05:18 |
| version GLIBCXX_3.4.9 and GLIBCXX_3.4.11 not found | ovie | Main CFD Forum | 1 | April 19, 2010 15:00 |
| [Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues | michele | OpenFOAM Meshing & Mesh Conversion | 2 | July 15, 2005 05:15 |
Linear Mode
