[snappyHexMesh] snappyHexMesh for Sloshing tank-reg.

hydraulist · March 23, 2016, 13:53

Hi,
I'm using the snappyHexMesh for the first time. The problem i'm dealing with is, sloshing tank with a vertical baffle placed at the mid length. The issue i'm facing is, after meshing with snappyHexMesh, i could not see any baffle( Baffle CAD file named as tank.stl) patch when i open it through paraFoam. I could see only the walls patch (walls of the tank) in the list. I've attached herewith the Dictionary i'm using.
Kindly suggest me your opinion on the possible cause of issue.

Thank you,

hydraulist · March 24, 2016, 02:10

Hello all,

I could correct the issue. Sorry, i did not notice that baffle was not present inside the tank domain (dimension mismatch). But one doubt is, i've used 250mm (0.25m baffle height required) baffle height while creating model in CATIA to fit into the tank of 0.75m height in OpenFOAM. But the dimensions did not match while importing to OpenFOAM. Could you tell the possible reason?

Thank you,

dybuk · March 24, 2016, 04:05

Probably CATIA export stl model in milimeters not in meters and there is an option to change export units to meters.
You can also scale stl file after export using surfaceTransformPoints utility.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
ANSYS Fluent Sloshing in baffled tank simulation	Fisya	CFD Freelancers	2	August 27, 2019 18:55
Rectangular Tank with collagen (or viscoelastic solid) inside - reg	srinc	OpenFOAM	0	March 25, 2019 10:23
Need Help! High pressure Gas discharge from tank to tank through a pipe	superarthur86	FLUENT	2	June 16, 2017 11:22
Snappyhexmesh vertical manifold pipe in tank [SOLVED]	spk363	Mesh Generation & Pre-Processing	1	February 17, 2016 20:51
Tank refuelling simulation	Bisht	STAR-CCM+	4	July 30, 2015 12:02

March 24, 2016, 02:10		#2
hydraulist New Member Join Date: Jul 2015 Posts: 12 Rep Power: 11	Hello all, I could correct the issue. Sorry, i did not notice that baffle was not present inside the tank domain (dimension mismatch). But one doubt is, i've used 250mm (0.25m baffle height required) baffle height while creating model in CATIA to fit into the tank of 0.75m height in OpenFOAM. But the dimensions did not match while importing to OpenFOAM. Could you tell the possible reason? Thank you,

March 24, 2016, 04:05		#3
dybuk Member W.T Join Date: Oct 2012 Posts: 35 Rep Power: 14	Probably CATIA export stl model in milimeters not in meters and there is an option to change export units to meters. You can also scale stl file after export using surfaceTransformPoints utility.