 |
 |
 |
|
|
|
[Sponsors] | ||||
[Other] Efficient 3D mesh topology for wind generetor blade, for CFD simulation |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
September 29, 2015, 00:22
|
Efficient 3D mesh topology for wind generetor blade, for CFD simulation
|
#1 |
|
Member
Eduardo Firvida
Join Date: Dec 2010
Posts: 53
Rep Power: 16  |
Hi I´m developing a tool to generate a openFoam wind tunnel case of wind turbine, I already have the blade geometry constructed as the pictures show.
My example blade I'm really new CFD and parametric meshing, I found some articles where mention a C topology to mesh the airfoil, also found a software (bladedesigner) that mention a topology named O10H, but none of these has a reference about how to implement this topologys and if are more topologys, or what are the best uses cases for each one. can someone give me a reference at least to begin my search about how to make an efficient mesh for my tool. Bladedesigner Topology O10H Diferent Kinds off C topology |
|
|
|
|
|
| Tags |
| airfoil 2d, airfoil 3d, airfoil mesh |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| sliding mesh problem in CFX | Saima | CFX | 46 | September 11, 2021 08:38 |
| Using coarse mesh and fine mesh in the same simulation | Satyajit92 | OpenFOAM Running, Solving & CFD | 0 | June 23, 2017 11:56 |
| Fatal overflow error, singularity, due to local mesh form? | Thomasbr | CFX | 7 | July 8, 2016 10:57 |
| [mesh manipulation] Importing Multiple Meshes | thomasnwalshiii | OpenFOAM Meshing & Mesh Conversion | 18 | December 19, 2015 19:57 |
| [snappyHexMesh] Layers:problem with curvature | giulio.topazio | OpenFOAM Meshing & Mesh Conversion | 10 | August 22, 2012 10:03 |
Linear Mode
