 |
 |
 |
|
|
|
[Sponsors] | ||||
May 9, 2015, 22:05
|
Baffles snappyhex
|
#1 |
|
New Member
Praveen Srikanth
Join Date: Jul 2012
Location: West Lafayette, IN
Posts: 23
Rep Power: 14  |
Hey,
I am trying to put in zero thickness guide vanes in a rectangular curved duct. The guide vanes are quarter circles. I was using Creo to model the guide vanes as surface extrusions and export it as an stl which i can then feed into snappy hex to mesh the whole duct with surface refinement close to the guide vanes. I am unable to export guide vane surfaces as an stl in creo. Is there any other way of doing this using snappy hex? Any help would be appreciated. Thank you so much |
|
|
|
|
 |
| Tags |
| baffles, creo, openfoam, snappyhexmesh |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [snappyHexMesh] snappyHexMesh does not create any mesh except one for the reference cell | Arman_N | OpenFOAM Meshing & Mesh Conversion | 1 | May 20, 2019 18:16 |
| [snappyHexMesh] SnappyHexMesh for internal Flow | vishwa | OpenFOAM Meshing & Mesh Conversion | 24 | June 27, 2016 09:54 |
| about modelling of baffles in Flow-3D | tecmia | FLOW-3D | 0 | September 24, 2012 10:27 |
| [snappyHexMesh] snappyHexMesh won't work - zeros everywhere! | sc298 | OpenFOAM Meshing & Mesh Conversion | 2 | March 27, 2011 22:11 |
| Rotary drum attached with baffles | nutow | CFX | 11 | November 12, 2010 15:36 |
Linear Mode
