[snappyHexMesh] Edge mesh distortion on searchableCylinder -- CFD Online Discussion Forums

April 30, 2015, 12:15

Edge mesh distortion on searchableCylinder

Romarius

New Member

Jishen Zhang

Join Date: Jun 2014

Location: Vigo, Spain

Posts: 12

Rep Power: 12

hello Foamers,

I am meshing a marine propeller in a box domain with blockMesh & snappyhexmesh.

I have created a user defined searchable cylinder that surrounds the propeller, but I have encountered a problem:

I cannot make shm snap well at the cylinder edges, so is there a way to conserve the form of a searchableCylinder like the way featureEdge does for a stl geometry?

Attached Images

distortion.jpg (101.3 KB, 54 views)

February 9, 2016, 12:47		#2
muhammss New Member M. Salman Siddiqui Join Date: Mar 2015 Posts: 16 Rep Power: 11	Hi, Now i am having the same problem. Did you find the solution? Please share.

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
sliding mesh problem in CFX	Saima	CFX	46	September 11, 2021 08:38
[snappyHexMesh] Creating multiple multiple cell zones with snappyHexMesh - a newbie in deep water!	divergence	OpenFOAM Meshing & Mesh Conversion	0	January 23, 2019 05:17
[ICEM] Hexa mesh, curve mesh setup, bunching law	Anorky	ANSYS Meshing & Geometry	4	November 12, 2014 01:27
Actuator disk model	audrich	FLUENT	0	September 21, 2009 08:06
[Commercial meshers] Star mesh import problem	chris1980	OpenFOAM Meshing & Mesh Conversion	20	May 8, 2006 02:07

All times are GMT -4. The time now is 02:11.