 |
 |
 |
|
|
|
[Sponsors] | ||||
October 21, 2014, 04:16
|
block merging with blockMesh
|
#1 |
|
Senior Member
Join Date: Feb 2010
Posts: 213
Rep Power: 17  |
Hi, I need to merge more blocks in order to model a room with inlet and outlet openings. I start with a very simplified case, just to set a preliminary case (see model.png).
I'm in doubt with mergePatchPairs and patch settings. 1. Should I define master and slave patches (see blockMesh)? 2.The inlet and outlet block faces don't match the whole face of the room block: how the wall boundary condition (and p and U values) is applied to the not-overlapped area of the bigger block? Thanks for your help. |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [blockMesh] blockMesh error - Negative Volume Block | adoledin | OpenFOAM Meshing & Mesh Conversion | 2 | June 22, 2016 11:44 |
| [blockMesh] blockMesh merging | ancolli | OpenFOAM Meshing & Mesh Conversion | 4 | May 13, 2016 19:11 |
| [blockMesh] External flow around cube with blockMesh | Woody8 | OpenFOAM Meshing & Mesh Conversion | 0 | March 31, 2015 15:54 |
| [Commercial meshers] Icem Mesh to Foam | jphandrigan | OpenFOAM Meshing & Mesh Conversion | 4 | March 9, 2010 03:58 |
| blockMesh: block with 6 vertexes | dani | OpenFOAM | 3 | June 25, 2009 14:13 |
Linear Mode
