 |
 |
 |
|
|
|
[Sponsors] | ||||
May 23, 2014, 07:57
|
Boundary layer
|
#1 |
|
New Member
Join Date: Oct 2009
Posts: 24
Rep Power: 17  |
I used snappyHexMesh to create these two meshes:
 1 layer BL:  2 layers BL:  I used featureAngle = 180 in both cases. Could you please tell me which parameter I should change to avoid the problems with 2 layers BL creation? doodek |
|
|
|
|
|
May 23, 2014, 08:54
|
|
#2 |
|
Senior Member
Eloïse
Join Date: Jul 2012
Location: Trondheim, Norway
Posts: 113
Rep Power: 14 |
Hello doodek,
Try first nGrow = 0 If you still have problem, try to relax the mesh quality parameters during layers creation (see Post #3 in this thread). Regards, Eloïse |
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Question about adaptive timestepping | Guille1811 | CFX | 25 | November 12, 2017 18:38 |
| Centrifugal fan-reverse flow in outlet lesds to a mass in flow field | xiexing | CFX | 3 | March 29, 2017 11:00 |
| Any formula for approximating the boundary layer thickness around a cylinder? | bestniaz | Main CFD Forum | 0 | October 24, 2015 03:00 |
| [ICEM] 3D Dynamic Mesh - Boundary layer mesh issues | nathanricks | ANSYS Meshing & Geometry | 0 | September 23, 2015 06:14 |
| Low Mixing time Problem | Mavier | CFX | 5 | April 29, 2013 01:00 |
Linear Mode
