 |
 |
 |
|
|
|
[Sponsors] | ||||
March 7, 2014, 10:40
|
Problem with snappyHexMesh
|
#1 |
|
Member
Join Date: Mar 2013
Posts: 98
Rep Power: 13  |
Hello to all,
I have a strange problem in the generation of the mesh with snappyHexMesh. When I created it, after the snap step, seems that some cells near the boundary are loss or not follows the boundary. I know that there are some thread about this problem but the solutions presented in their don't work. During the snap step appears this warming: FOAM Warning : Displacement (-4.016316e-07 1.993513e-06 5.287614e-08) at mesh point 14338 coord (0.009952381 0.04995016 -0.0009597589) points through the surrounding patch faces Smoothing displacement Displacement smoothed in = 8.69 s Moving mesh ... Is this warming related to the error? My geometry is very simple: a rectangular with a cylinder inside. I attach some pictures related to the error. Someone know what is the problem? Thanks to all for the willingness |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [snappyHexMesh] Problem with decomposePar, snappyHexMesh | luca1992 | OpenFOAM Meshing & Mesh Conversion | 12 | August 23, 2017 20:06 |
| [snappyHexMesh] snappyHexMesh problem | cfdsolver1 | OpenFOAM Meshing & Mesh Conversion | 0 | June 23, 2016 11:09 |
| [snappyHexMesh] Problem handling with subdictionary in SnappyHexMesh | Lorenzo92 | OpenFOAM Meshing & Mesh Conversion | 0 | November 21, 2015 14:57 |
| [snappyHexMesh] Problem with snappyhexMesh: modelling a pore chamber and pore throat model | Saideep | OpenFOAM Meshing & Mesh Conversion | 5 | May 10, 2015 15:46 |
| [snappyHexMesh] Problem with snappyHexMesh | giack | OpenFOAM Meshing & Mesh Conversion | 2 | September 18, 2014 11:03 |
Linear Mode
