[snappyHexMesh] Help with snappyHexMeshDict parameters -- CFD Online Discussion Forums

March 4, 2014, 17:52

Help with snappyHexMeshDict parameters

lowis5

New Member

Join Date: Mar 2014

Posts: 1

Rep Power: 0

Hi,
I have a little CFD experience and I'm trying to use openFOAM to determine the drag coefficient for a few shapes. I know that eventually I must use a turbulence model, but for now I've managed to run a preliminary transient simulation using icoFOam. However, the Courant number blows up unless I use dt=0.0001 or close to that. I suspect that my mesh may be the problem since I go this warning from checkMesh:
***Max skewness = 4.68373, 1 highly skew faces detected which may impair the quality of the results
Could someone please take a look at my setup and recommend better parameter values for the snappyHexMeshDict? I'm attaching the required files in SnappyFiles.zip and a sketch of the physical domain in Domain.zip
Thanks so much,

Lowis5

Attached Files

	SnappyFiles.zip (35.3 KB, 7 views)
	Domain.zip (74.3 KB, 5 views)

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Parameters of a good airfoil mesh	CharlieBra7o	Mesh Generation & Pre-Processing	4	November 20, 2018 15:42
Pro/E to ANSYS Parameterization Guide	Trues	ANSYS	4	April 18, 2018 06:52
Parameters rhoSimpleFoam	marcus85	OpenFOAM Pre-Processing	0	May 15, 2013 10:36
Turbulence model parameters and equations	Maximus91	Main CFD Forum	1	October 24, 2012 14:20
Parameters for multigrid solver	HaZe	OpenFOAM Running, Solving & CFD	3	January 28, 2012 03:05

All times are GMT -4. The time now is 00:40.