 |
 |
 |
|
|
|
[Sponsors] | ||||
May 21, 2013, 06:13
|
extrude mesh
|
#1 |
|
New Member
André Zboralski
Join Date: Jan 2013
Posts: 11
Rep Power: 13  |
hallo everyone,
i greated a mesh by some stl-files by using snappyHeyMesh. the cells near the inlet patch are very complex, so I tried extrude a additional mesh in the other direction. but i can´t see the finalresult in the last time step. i can see the additional mesh (greated by extrudemesh) in the first time step. does i need a special command? thank you! |
|
|
|
|
 |
| Tags |
| extrude, extrude mesh |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| sliding mesh problem in CFX | Saima | CFX | 46 | September 11, 2021 08:38 |
| GMSH extrude a boundary layer from an unstructured Mesh | Hillie | Mesh Generation & Pre-Processing | 2 | July 7, 2017 04:38 |
| [ICEM] Extrude mesh | luissanchez | ANSYS Meshing & Geometry | 2 | June 25, 2013 09:22 |
| [ICEM] issue occur after extrude 2D airfoil mesh and convergence problem in CFX | shiyun | ANSYS Meshing & Geometry | 4 | May 9, 2012 20:55 |
| [snappyHexMesh] snappyHexMesh won't work - zeros everywhere! | sc298 | OpenFOAM Meshing & Mesh Conversion | 2 | March 27, 2011 22:11 |
Linear Mode
