|
[Sponsors] |
May 2, 2013, 05:49 |
mergeMeshes and AMI
|
#1 |
Senior Member
Paritosh Vasava
Join Date: Oct 2012
Location: Lappeenranta, Finland
Posts: 732
Rep Power: 23 |
I am making a simulation for mixing processs with an impeller. I have been following the example describing rotating cube in a flow field. (http://www.cfd-online.com/Forums/ope...wing-up-2.html)
Here is what I did 1. I divided the domain in to two parts: a. Region close to the impeller blades. b. The mixing tank (minus the region described by 'a'). 2. Created two meshes. 3. Use mergeMesh operation to merge the mesh. Now, I have following problem/questions. 1. The method I followed did not generate any AMI. What could be wrong? 2. Is it necessary to have conformal meshes to generate AMI? 3. Is there any separate process/file/command to generate AMI? |
|
May 3, 2013, 04:35 |
|
#2 |
Senior Member
Paritosh Vasava
Join Date: Oct 2012
Location: Lappeenranta, Finland
Posts: 732
Rep Power: 23 |
Can some one explain method to generate AMI?
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Rotating Mesh, errors in Cyclic AMI interface | WhiteW | OpenFOAM | 2 | September 26, 2016 10:12 |
[mesh manipulation] Combining two meshes for AMI of rotating turbine | mahtin360 | OpenFOAM Meshing & Mesh Conversion | 0 | October 2, 2014 04:06 |
Trouble with simple AMI case | Horus | OpenFOAM | 0 | February 26, 2013 10:31 |
Keep sets when mergeMeshes | Horus | OpenFOAM | 1 | January 2, 2013 07:51 |
[Other] AMI rotating domain meshing errors | Attesz | OpenFOAM Meshing & Mesh Conversion | 1 | April 25, 2012 06:29 |