[blockMesh] Problem with arc edge, arc doesen't appear in ParaFoam

A.A. · August 31, 2012, 11:56

Hi,

I have a problem with arc edges in my mesh, they don't appear in paraFoam although they are defined correctly. I defined these arc edges like many others in my mesh but only some don't work.

Why is that, can anybody help me with this problem.

I have attached a picture were the missing arc is red circled. Please find also attached the blockMeshDict file. You can find this arc between vertices 4 and 7 in the blockMeshDict file (arc 4 7 (-100 0 300)).

(To get these arcs would be of important value for me in order to create cyclic AMI patches with these faces.)

Many thanks in advance,
Alex

wyldckat · September 3, 2012, 17:18

Hi Alexander,

I got the PM you sent me. Right now I'm working on fumes and really tired, so the best I can suggest is this:

You can diagnose your "blockMeshDict" with this command:
Code:
```
paraFoam -block
```
You can confirm this option by running:
Code:
```
paraFoam -help
```
Use SwiftBlock: http://openfoamwiki.net/index.php/Contrib/SwiftBlock
I'm not 100% certain if it will work for what you need to do, but at least it might help you get closer to the solution.

Good luck!
Bruno

A.A. · September 4, 2012, 08:01

Hi Bruno,

Thank you very much I got the problem now.

Regards,
Alex

September 3, 2012, 17:18		#2
wyldckat Retired Super Moderator Bruno Santos Join Date: Mar 2009 Location: Lisbon, Portugal Posts: 10,981 Blog Entries: 45 Rep Power: 128	Hi Alexander, I got the PM you sent me. Right now I'm working on fumes and really tired, so the best I can suggest is this: You can diagnose your "blockMeshDict" with this command: Code: paraFoam -block You can confirm this option by running: Code: paraFoam -help Use SwiftBlock: http://openfoamwiki.net/index.php/Contrib/SwiftBlock I'm not 100% certain if it will work for what you need to do, but at least it might help you get closer to the solution. Good luck! Bruno __________________ OpenFOAM: FAQ \| Getting started Forum: How to get help, to post code/output and forum guide Read this before sending me PM

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[blockMesh] Openfoam: Meshing, where do my defaultFaces come from	syntex	OpenFOAM Meshing & Mesh Conversion	19	December 10, 2018 08:21
[blockMesh] Another cylinder question	bendel_boy	OpenFOAM Meshing & Mesh Conversion	5	January 6, 2015 06:09
[blockMesh] 4 inlets to 1 outlet and potential internal faces	ElsaStegosaurus	OpenFOAM Meshing & Mesh Conversion	10	May 16, 2013 10:05
[blockMesh] error message with modeling a cube with a hold at the center	hsingtzu	OpenFOAM Meshing & Mesh Conversion	2	March 14, 2012 10:56
fluent add additional zones for the mesh file	SSL	FLUENT	2	January 26, 2008 12:55

September 4, 2012, 08:01		#3
A.A. Member Alexander A Join Date: Jun 2012 Posts: 53 Rep Power: 14	Hi Bruno, Thank you very much I got the problem now. Regards, Alex