 |
 |
 |
|
|
|
[Sponsors] | ||||
[Other] The problem regarding 3D scour using sedfoam |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
August 1, 2021, 07:38
|
The problem regarding 3D scour using sedfoam
|
#1 |
|
Senior Member
kimy
Join Date: Mar 2019
Location: https://t.me/pump_upp
Posts: 164
Rep Power: 7     |
Hi,
I am using sedFoam to simulate three-dimensional scour around a pile under steady flow. However, I am not sure how to modify the inlet velocity if the inlet and inner field are mapped with a 1D sedimentation case in which no inlet velocity is specified. Thus, is it correct if I mapped the 1D case result into a 3D case and then change the inlet velocity of liquid only or both two phases? any suggestion will be greatly appreciated. |
|
|
|
|
|
| Tags |
| boundary condition., scour, sedfoam |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| SU2-7.0.1 on ubuntu 18.04 | hyunko | SU2 Installation | 7 | March 16, 2020 05:37 |
| BuoyantBoussinesqSimpleFoam_Facing problem | Mondal131211 | OpenFOAM Running, Solving & CFD | 1 | April 10, 2019 20:41 |
| Mesh& steptime independant: conduction-convection problem | Fati1 | Main CFD Forum | 1 | October 28, 2018 14:52 |
| Gambit - meshing over airfoil wrapping (?) problem | JFDC | FLUENT | 1 | July 11, 2011 06:59 |
| Adiabatic and Rotating wall (Convection problem) | ParodDav | CFX | 5 | April 29, 2007 20:13 |
Linear Mode
