 |
 |
 |
|
|
|
[Sponsors] | ||||
[cfMesh] improveMeshQuality does not move points on wall patches |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
November 18, 2020, 13:08
|
improveMeshQuality does not move points on wall patches
|
#1 |
|
Senior Member
Gerhard Holzinger
Join Date: Feb 2012
Location: Austria
Posts: 342
Rep Power: 28  |
The attached image shows a mesh (created by blockMesh) on which I have applied improveMeshQuality.
On the left, a crinkle clip (y-normal) is shown. On the right, a crinkle slice (x-normal) is shown. Thus, we see on left the wall patch, whereas on the right, we see the internal mesh three cell layers into the mesh. If we only view the surface mesh, improveMeshQuality does not seem to have done anything, however, the internal mesh clearly shows that the mesh has been smoothed. How can I make improveMeshQuality also work on the surface? |
|
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [snappyHexMesh] layer not added | Rasmusiwersen | OpenFOAM Meshing & Mesh Conversion | 1 | January 2, 2020 10:43 |
| [blockMesh] mergePatchPairs reducing a face to less than 3 points | aow | OpenFOAM Meshing & Mesh Conversion | 2 | June 1, 2018 18:37 |
| [mesh manipulation] Importing Multiple Meshes | thomasnwalshiii | OpenFOAM Meshing & Mesh Conversion | 18 | December 19, 2015 19:57 |
| [mesh manipulation] DynamicMesh - Move internal points | nucat | OpenFOAM Meshing & Mesh Conversion | 2 | September 6, 2014 09:54 |
| problem with cyclicAMI and wall distance | Maff | OpenFOAM Bugs | 5 | August 14, 2014 15:41 |
Linear Mode
