 |
 |
 |
|
|
|
[Sponsors] | ||||
[swak4Foam] is it possible to apply more than one cell in zeroGradient or groovyBC internalField? |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
February 8, 2013, 16:37
|
is it possible to apply more than one cell in zeroGradient or groovyBC internalField?
|
#1 |
|
Senior Member
Ehsan
Join Date: Oct 2012
Location: Iran
Posts: 2,208
Rep Power: 27  |
at my run the cells that are neighbours to outlet boundary show a high value for pressure and velocity that is unrealistic.I guess it can be from one cell getting in zeroGradient and also first order interpolation in internalField utility.
can a second order interpolation be used?how or any hint is appreciated. thanks. |
|
|
|
|
|
February 8, 2013, 18:15
|
|
#2 | |
|
Assistant Moderator
Bernhard Gschaider
Join Date: Mar 2009
Posts: 4,225
Rep Power: 51 |
Quote:
What is usually the problem in such cases is using a plain zeroGradient condition and having backflow at the outlet. Either extend the outlet to eliminate backflow or use the inletOutlet-condition (or something similar) to have a Dirichlet-conditon for faces where flow comes back in
__________________
Note: I don't use "Friend"-feature on this forum out of principle. Ah. And by the way: I'm not on Facebook either. So don't be offended if I don't accept your invitation/friend request |
||
|
|
|
||
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [OpenFOAM.org] Compile OF 2.3 on Mac OS X .... the patch | gschaider | OpenFOAM Installation | 225 | August 25, 2015 20:43 |
| [swak4Foam] Is it possible to apply groovyBC to surfaceflux phi? | hrushi.397 | OpenFOAM Community Contributions | 1 | May 25, 2015 17:47 |
| interFoam running blowing up | sandy13 | OpenFOAM Running, Solving & CFD | 2 | May 5, 2015 08:16 |
| multiphaseInterFoam: timestep error by simulating a co-extrusion nozzle | Quatschinsky | OpenFOAM Running, Solving & CFD | 7 | March 27, 2014 06:08 |
| [swak4Foam] how is it possible to apply different BC's for regime of flow in groovyBC? | immortality | OpenFOAM Community Contributions | 1 | February 4, 2013 02:55 |
Linear Mode
