[universez]

I am new to OF. This is the error message when I run potentialFoam with OF 1.6.

would some one tell why and how to fix.

Thanks,


/*---------------------------------------------------------------------------*\
| ========= | |
| \\ / F ield | OpenFOAM: The Open Source CFD Toolbox |
| \\ / O peration | Version: 1.6 |
| \\ / A nd | Web: www.OpenFOAM.org |
| \\/ M anipulation | |
\*---------------------------------------------------------------------------*/
Build : 1.6-53b7f692aa41
Exec : potentialFoam
Date : Mar 31 2010
Time : 14:05:29
Host : yu-desktop
PID : 6144
Case : /home/yu/OpenFOAM/yu-1.6/run/cylinder
nProcs : 1
SigFpe : Enabling floating point exception trapping (FOAM_SIGFPE).

// * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * //
Create time

Create mesh for time = 0

Reading field p

Reading field U


Calculating potential flow
DICPCG: Solving for p, Initial residual = 1, Final residual = 7.87053e-07, No Iterations 76
DICPCG: Solving for p, Initial residual = 0.0126511, Final residual = 7.87996e-07, No Iterations 64
DICPCG: Solving for p, Initial residual = 0.00272823, Final residual = 9.14557e-07, No Iterations 58
DICPCG: Solving for p, Initial residual = 0.00100302, Final residual = 9.16454e-07, No Iterations 50
continuity error = 3.6372e-05
Interpolated U error = 2.76513e-05
ExecutionTime = 0.09 s ClockTime = 1 s

End

[mattijs]

There is no error. It has calculated internal values for velocity field U (and flux phi) consistent with your supplied boundary conditions. Check 0/U.

[Madhura]

In the module mentioned above, the start time is 0 and end time is 1. So the o/p directory should show the files for time 0 and 1 (the time-step is 1). But it does not show files for 1. Could somebody help with that?

Thanks

[darioth]

There are no errors above. After that, type foamToVTK and open the /VTK/cylinder.vtk file in Paraview to see the results. I hope this help.