 |
 |
 |
|
|
|
[Sponsors] | ||||
March 15, 2010, 15:23
|
HashTable Binary write format
|
#1 |
|
Senior Member
Sandeep Menon
Join Date: Mar 2009
Location: Amherst, MA
Posts: 403
Rep Power: 25  |
Not sure if this is a bug, but nevertheless...
It appears that HashTable contents cannot be written in binary format to disk (but ascii with either compressed/uncompressed works just fine). Is this a limitation of the binary format (due to coding complications, etc)? Or has it just not been implemented yet? With the write-option in controlDict set to binary, the HashTable header specifies "binary", but the contents are still in ASCII form. This becomes problematic during the re-read from disk. I'm using 1.5-dev, by the way... |
|
|
|
|
|
March 16, 2010, 11:03
|
|
#2 |
|
Senior Member
Join Date: Mar 2009
Posts: 854
Rep Power: 22 |
I have tested binary IO of HashTable in OpenFOAM-1.6.x and it works fine. Are you able to reproduce the problem in OpenFOAM-1.6.x? If so could you send a code example which reproduces the problem?
H |
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| How to write Tecplot binary file(.plt) in CFD code on Linux 64 platform? | markailee | Tecplot | 5 | December 16, 2010 08:03 |
| Error to re-open fluent case file | J.Gimbun | FLUENT | 0 | April 27, 2006 09:42 |
| Binary File format for Tecplot | CFD Student | Tecplot | 3 | February 27, 2006 06:29 |
| Who can write the binary diffusion coefficient ?? | Hsin-Ping | FLUENT | 1 | April 15, 2002 03:22 |
| Sliding mesh error | Karl Kevala | FLUENT | 4 | February 21, 2001 16:52 |
Linear Mode
