 |
 |
 |
|
|
|
[Sponsors] | ||||
January 29, 2007, 05:57
|
I apply the inletOutletBoundar
|
#1 |
|
Senior Member
Rasmus Hemph
Join Date: Mar 2009
Location: Sweden
Posts: 108
Rep Power: 17  |
I apply the inletOutletBoundary condition on the outlet, with a zero inlet velocity for the fluid, but still get influx through some faces. Should this be possible?
A picture of the (converged) flow field can be seen here: http://www.tfd.chalmers.se/~md8hemra/images/outflow.png The Ub-velocity field on the influx faces is zero in the output file as they should, but the corresponding phib-field is not equal to zero. It appears that phib and Ub are not connected on the inflow faces. A test case can be downloaded from http://www.tfd.chalmers.se/~md8hemra...stCase2.tar.gz The flow behavior appears after about 1.5 seconds. |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Inletoutlet | rengu | OpenFOAM Running, Solving & CFD | 8 | December 25, 2015 16:44 |
| InletOutlet condition with arbitrary direction | matteoc | OpenFOAM Running, Solving & CFD | 8 | May 31, 2011 07:49 |
| Cyclic inletoutlet with icoFoam | sripplinger | OpenFOAM Running, Solving & CFD | 5 | November 8, 2008 05:48 |
| Velocity Jump at InletOutlet | cliffoi | OpenFOAM Running, Solving & CFD | 0 | September 8, 2008 06:34 |
| TwoPhaseEulerFoam and InletOutlet boundary condition | hemph | OpenFOAM Running, Solving & CFD | 10 | January 29, 2007 10:47 |
Linear Mode
