WordstripInvalid in snappyHexMesh

nitsud · August 6, 2008, 01:41

Having a problem with snappyHexMesh and a stl file that I've been playing with. Getting the error:
word::stripInvalid() called for word �>J
�=
For debug level (= 2) > 1 this is considered fatal
Aborted

nitsud · August 6, 2008, 01:49

Accidentially submitted before I was done... In any case, I read previous postings and understand that there must be an illegal character somewhere, but I'm not sure where to look for it. Any help is appreciated!!
Thanks,
Dustin

mattijs · August 6, 2008, 05:20

Check the stl file with an editor. Look at the 'solid' tag. Maybe there are spaces or illegal characters in it?

nitsud · August 6, 2008, 23:30

I was attempting to use a binary .stl file that I had output from Solidworks, and when I used an ascii file, all went well. Not sure exactly what the problem there is, and it's very hard to troubleshoot in binary.

In any case, thanks much for the help!!
Dustin

August 6, 2008, 01:41	Having a problem with snappyHe	#1
nitsud New Member Dustin Join Date: Mar 2009 Posts: 6 Rep Power: 17	Having a problem with snappyHexMesh and a stl file that I've been playing with. Getting the error: word::stripInvalid() called for word �>J �= For debug level (= 2) > 1 this is considered fatal Aborted

August 6, 2008, 01:49	Accidentially submitted before	#2
nitsud New Member Dustin Join Date: Mar 2009 Posts: 6 Rep Power: 17	Accidentially submitted before I was done... In any case, I read previous postings and understand that there must be an illegal character somewhere, but I'm not sure where to look for it. Any help is appreciated!! Thanks, Dustin

August 6, 2008, 05:20	Check the stl file with an edi	#3
mattijs Senior Member Mattijs Janssens Join Date: Mar 2009 Posts: 1,419 Rep Power: 26	Check the stl file with an editor. Look at the 'solid' tag. Maybe there are spaces or illegal characters in it?

August 6, 2008, 23:30	I was attempting to use a bina	#4
nitsud New Member Dustin Join Date: Mar 2009 Posts: 6 Rep Power: 17	I was attempting to use a binary .stl file that I had output from Solidworks, and when I used an ascii file, all went well. Not sure exactly what the problem there is, and it's very hard to troubleshoot in binary. In any case, thanks much for the help!! Dustin

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[snappyHexMesh] SnappyHexMesh in 2D case	sjs	OpenFOAM Meshing & Mesh Conversion	12	November 8, 2019 05:51
WordstripInvalid in twoPhaseEulerFoam	alberto	OpenFOAM Running, Solving & CFD	6	December 20, 2011 12:02
[snappyHexMesh] SnappyHexMesh	erik023	OpenFOAM Meshing & Mesh Conversion	19	October 17, 2010 11:09
[snappyHexMesh] SnappyHexMesh in Parallel	bastil	OpenFOAM Meshing & Mesh Conversion	22	April 7, 2010 12:48
[snappyHexMesh] SnappyHexMesh	mp340	OpenFOAM Meshing & Mesh Conversion	1	November 13, 2008 14:30