|
[Sponsors] |
![]() |
![]() |
#1 |
New Member
Join Date: Mar 2024
Posts: 2
Rep Power: 0 ![]() |
I have created a non uniform area rectangular body. I want a structured mesh with finer grid size near the walls, I have done premesh and converted it to unstruct mesh. But exactly at the midplane I am getting this kind of mesh (attached in the image). Other than the midplane i am getting uniform structured mesh without any irregularities. May i know the reason. I need a uniform mesh in the midplane which gives me non symmetrical results in CFX. What am i doing wrong?
|
|
![]() |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Gmsh] Vertex numbering is dense | KateEisenhower | OpenFOAM Meshing & Mesh Conversion | 7 | August 3, 2015 10:49 |
Meshing a Mixing Plane in ICEM | Will Anderson | ANSYS Meshing & Geometry | 2 | November 9, 2010 09:16 |
Meshing a Mixing Plane using ICEM | Will Anderson | FLUENT | 0 | November 6, 2010 17:08 |
[ICEM] ICEM meshing problem | xyq102296 | ANSYS Meshing & Geometry | 6 | October 28, 2010 10:09 |
ICEM meshing question | gsbhatia89 | ANSYS Meshing & Geometry | 5 | June 14, 2010 08:24 |