|
[Sponsors] |
Hexa Mesh for a Round Tip, Sharp TE Prop Blade |
![]() |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
![]() |
![]() |
#1 |
New Member
Join Date: May 2018
Location: Turkey
Posts: 22
Rep Power: 8 ![]() |
Hey everyone,
I'm trying to create a hex-mesh for a propeller blade with a round tip and a sharp TE. I'm using ICEM CFD. I've tried various permutations of O-Grid, Collapse Blocks etc. however unsuccessfully. It would be appreciated if the community can throw in some ideas regarding possible blocking strategies for this particular case. The fluid domain is an H-grid type. For the blade stations, I want to make either C or O grid. The problem where I'm stuck remains the blade tip. Ideas are welcome. Thanks. |
|
![]() |
![]() |
![]() |
Tags |
hexa blocking, icem 14.0, propeller mesh generating |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] Hexa mesh, curve mesh setup, bunching law | Anorky | ANSYS Meshing & Geometry | 4 | November 12, 2014 00:27 |
Moving mesh | Niklas Wikstrom (Wikstrom) | OpenFOAM Running, Solving & CFD | 122 | June 15, 2014 06:20 |
Solution on hexa mesh vs solution on tetra mesh | Chander | CFX | 2 | December 10, 2011 09:35 |
[ICEM] Turbine blade with filleting and tip clearance | Pursuor | ANSYS Meshing & Geometry | 4 | July 7, 2010 13:56 |
Convergence moving mesh | lr103476 | OpenFOAM Running, Solving & CFD | 30 | November 19, 2007 14:09 |