 |
 |
 |
|
|
|
[Sponsors] | ||||
July 24, 2019, 10:46
|
SALOME Meshing 3D extrusion
|
#1 |
|
New Member
Frédéric MR
Join Date: Jun 2019
Posts: 18
Rep Power: 7  |
Hi CFD users (and more specifically SALOME users),
I am meshing a geometry on which I can / want extrude 2d mesh along an edge. However, depending on how I prepare my geometry, the 3d meshing algorithm (advanced > 3D extrusion) is available or not. How can I be sure this algorithm is available? What are compulsory parameters? Thanks a lot for your answer. FM |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Meshing with Salome | samiam1000 | OpenFOAM Pre-Processing | 2 | October 4, 2013 14:22 |
| thin extrusion meshing | guillaume | Phoenics | 0 | October 27, 2008 19:39 |
| thin extrusion meshing | guillaume | Fidelity CFD | 0 | October 27, 2008 19:39 |
| thin extrusion meshing | guillaume | Main CFD Forum | 0 | October 27, 2008 19:36 |
| Best Meshing scheme for Cylinder | Nutrex | Main CFD Forum | 4 | July 29, 2008 12:03 |
Linear Mode
