 |
 |
 |
|
|
|
[Sponsors] | ||||
February 9, 2017, 22:28
|
Mesh generation for a geometry
|
#1 |
|
Senior Member
raunak jung pandey
Join Date: Jun 2016
Posts: 102
Rep Power: 10  |
Hello Everyone
I need some help to carry out meshing on this feature of geometry as is shown in the figure. I tried to capture the curved exterior without creating O-grid but it resulted in highly skewed meshes. When I carry out O-grid meshing the feature is captured but the gradient in mesh size increases drastically. What would be a good meshing strategy for this geometry?I can use ICEM and Ansys Meshing. I need to create a hexahedral mesh.  Thank You |
|
|
|
|
 |
| Tags |
| curve, icem |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [GAMBIT] mesh generation and geometry creation packed bed reactors | manuc | ANSYS Meshing & Geometry | 6 | April 12, 2016 03:24 |
| [snappyHexMesh] SnappyHexMesh no layers and no decent mesh for complex geometry | pizzaspinate | OpenFOAM Meshing & Mesh Conversion | 1 | February 25, 2015 08:05 |
| Geometry and mesh generation in OpenFoam | pokeng | OpenFOAM Pre-Processing | 1 | October 28, 2011 22:40 |
| Latest News in Mesh Generation | Robert Schneiders | Main CFD Forum | 1 | February 18, 2000 01:48 |
| Latest news in mesh generation | Robert Schneiders | Main CFD Forum | 0 | March 2, 1999 05:07 |
Linear Mode
