bc mixed/unknown rectification

aravind vashista · January 11, 2017, 13:21

hii all,
i have been trying to mesh the model given below. i have a wedge shaped geometry inside main body. the wedge has 15 holes which is inlet for another fluid,after i create block and mesh, i endup getting mixed/unknown surfaces in boundary condition. how to make it one sided. i.e how to mesh those 15 holes. i have created blocks as shown and have done edge to cure association.
sj003002.jpg

sj001.jpg001.jpg

sj002.jpg for all 15 holes.
thank you for your patience for reading and please reply asap if u guys could help me

mehran.mo · June 27, 2018, 08:51

i have this problem too if you find it please tell me
thanks

January 11, 2017, 13:21	bc mixed/unknown rectification	#1
aravind vashista Member ARAVIND SRIDHARA Join Date: Jan 2017 Posts: 32 Rep Power: 9	hii all, i have been trying to mesh the model given below. i have a wedge shaped geometry inside main body. the wedge has 15 holes which is inlet for another fluid,after i create block and mesh, i endup getting mixed/unknown surfaces in boundary condition. how to make it one sided. i.e how to mesh those 15 holes. i have created blocks as shown and have done edge to cure association. sj003002.jpg sj001.jpg001.jpg sj002.jpg for all 15 holes. thank you for your patience for reading and please reply asap if u guys could help me

June 27, 2018, 08:51	mixed/unknow boundary	#2
mehran.mo New Member mehran mohammadi Join Date: Aug 2016 Posts: 13 Rep Power: 10	i have this problem too if you find it please tell me thanks

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[ICEM] meshing error rectification	rsskarthikeyan	ANSYS Meshing & Geometry	0	February 23, 2013 01:54
ANSYS error rectification	rsskarthikeyan	FLUENT	0	October 27, 2012 14:27