|
[Sponsors] |
December 12, 2016, 12:59 |
Mesh
|
#1 |
New Member
A
Join Date: May 2016
Posts: 21
Rep Power: 0 |
I am simulating ANSYS CFX centrifugal pump rotor, I use ANSYS MESHing, my logarithmic layer Y + 500 is 5.05e-3 with 20 prism cells, in ANSYS POST I check the YPlus values of Inlet, Outlet between 30 and 50, however, in the region of the blades I found values of Y + of 700, I tried to reduce the value of the first layer in the mesh, but with no result! What can it be? Does anyone know how I solve this problem?
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
sliding mesh problem in CFX | Saima | CFX | 46 | September 11, 2021 08:38 |
Star CCM Overset Mesh Error (Rotating Turbine) | thezack | Siemens | 7 | October 12, 2016 12:14 |
[ICEM] surface mesh merging problem | everest | ANSYS Meshing & Geometry | 44 | April 14, 2016 07:41 |
[ICEM] Problem making structural mesh on a surface | froztbear | ANSYS Meshing & Geometry | 1 | November 10, 2011 09:52 |
[snappyHexMesh] snappyHexMesh won't work - zeros everywhere! | sc298 | OpenFOAM Meshing & Mesh Conversion | 2 | March 27, 2011 22:11 |