|
[Sponsors] |
ICEM - mesh generation for conjugate heat transfer problems |
![]() |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
![]() |
![]() |
#1 |
New Member
Anderson
Join Date: Feb 2013
Posts: 11
Rep Power: 13 ![]() |
Hi
I am new in ICEM. I want to generate mesh for a simple example of conjugate heat transfer. My geometry is a 3D tube by considering wall thickness (solid) which I want to simulate fluid flow on the tube. the schematic of my geometry has been shown in follow (image in cylindrical coordinate) : -------------------------------------- solid ------------------------------------- Fluid ------------------------------------- solid ------------------------------------ I created this geometry in Ansys design Modeler. then i imported it in ICEM I defined two boxes for solid and Fluid. but there is a problem which is overlapping of boxes. after creating meshes, two meshes is shown for fluid and i dont know how can i solve this problem |
|
![]() |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Radiation in semi-transparent media with surface-to-surface model? | mpeppels | CFX | 11 | August 22, 2019 08:30 |
[snappyHexMesh] No layers in a small gap | bobburnquist | OpenFOAM Meshing & Mesh Conversion | 6 | August 26, 2015 10:38 |
Moving mesh | Niklas Wikstrom (Wikstrom) | OpenFOAM Running, Solving & CFD | 122 | June 15, 2014 07:20 |
Heat transfer from a heated plate using fins | pathakamit | FLUENT | 1 | April 30, 2013 05:07 |
Convective / Conductive Heat Transfer in Hypersonic flows | enigma | Main CFD Forum | 2 | November 1, 2009 23:53 |