 |
 |
 |
|
|
|
[Sponsors] | ||||
January 7, 2016, 13:11
|
Dynamic meshing
|
#1 |
|
New Member
Jeeva Muthulingam
Join Date: Jan 2016
Posts: 3
Rep Power: 10  |
Negative cell volume detected, any help to solve this
|
|
|
|
|
|
January 21, 2016, 02:47
|
|
#2 |
|
New Member
mohsen
Join Date: Jun 2015
Posts: 25
Rep Power: 11 |
Hi
Plz, explain more, if it's happens during run and you have just one domain , you have to reduce time step , actually the time step must be smaller than cell dimensions. If time step is small enough and you meet that error again, you must check your boundary conditions for true setting, sometimes this error accrued when some boundary moves but another boundary that linked with that not move. |
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| CFD simulation of gas cicrcuit breaker in fluent with dynamic meshing. | Mahesh7238 | FLUENT | 1 | April 5, 2021 01:21 |
| Dynamic Meshing of Simple 2D Geometry | harman79 | FLUENT | 2 | January 17, 2018 07:07 |
| UDF for dynamic meshing? | prasaddeole | FLUENT | 2 | October 6, 2014 12:55 |
| negative cell volume during dynamic meshing | Tamjid | FLUENT | 1 | September 5, 2011 03:33 |
| [GAMBIT] Dynamic Meshing of a combustion chamber | donarundas | ANSYS Meshing & Geometry | 1 | December 2, 2009 08:13 |
Linear Mode
