|
[Sponsors] |
![]() |
![]() |
#1 |
New Member
Ehsan Akrami
Join Date: Aug 2012
Location: Ireland
Posts: 9
Rep Power: 14 ![]() |
Hi guys .
I want to modeling a axial impeller rotating in the middle of a pipe ![]() ![]() |
|
![]() |
![]() |
![]() |
![]() |
#2 |
New Member
Morteza Teymoori
Join Date: Jan 2013
Location: Iran
Posts: 3
Rep Power: 13 ![]() |
well I,personally used ICEM CFD and prefer to use that as well for every problem. I also read before that it is the best Meshing software available.
but you should dig a little more to get the best answer. ![]() |
|
![]() |
![]() |
![]() |
![]() |
#3 |
Senior Member
Colinda
Join Date: May 2012
Location: Brussels
Posts: 153
Rep Power: 14 ![]() |
For an impeller or any turbomachinery configuration in general AutoGrid5 offers structured grids of high quality.
|
|
![]() |
![]() |
![]() |
![]() |
#4 |
Member
Peter
Join Date: Feb 2015
Location: New York
Posts: 73
Rep Power: 11 ![]() |
Here's a simple, free preprocessor. Its a plugin for Sketchup (http://www.sketchup.com)(also free) to facilitate mesh generation with Tetgen (http://wias-berlin.de/software/tetgen/) . Supports complex geometry, multiple regions, boundaries, and refinement (both boundary and volume based).
Check it out: https://extensions.sketchup.com/en/c...y-tetgen-tools Hope this helps! Regards, Peter |
|
![]() |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Gambit problems | Althea | FLUENT | 22 | January 4, 2017 03:19 |
Mesh motion with Translation & Rotation | Doginal | CFX | 2 | January 12, 2014 06:21 |
New Mesh Generation and Pre-Processing Forums | pete | Site News & Announcements | 2 | December 26, 2012 17:56 |
Mesh generation software is needed | H.Dou | Main CFD Forum | 12 | May 4, 2011 15:20 |
General questions on grid-based computing | Adrin Gharakhani | Main CFD Forum | 21 | June 5, 2000 13:47 |