 |
 |
 |
|
|
|
[Sponsors] | ||||
May 25, 2011, 08:24
|
problem with KIVA3V
|
#1 |
|
New Member
Vijay Paul
Join Date: May 2011
Posts: 4
Rep Power: 15  |
I am using KIVA3V to simulate a flow with an outflow boundary. The code
does not seem to be affected by ambient pressure at all (subsonic flow). The exit pressure should equal the ambient pressure. The iterations do not converge because exit pressure is turning out to be 1.0 (CGS units) and I am not sure where it is being set in the source code. Any help would be greatly appreciated. Thanks. |
|
|
|
|
 |
| Tags |
| kiva3v, outflow condition |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| UDF compiling problem | Wouter | Fluent UDF and Scheme Programming | 6 | June 6, 2012 05:43 |
| Incoherent problem table in hollow-fiber spinning | Gianni | FLUENT | 0 | April 5, 2008 11:33 |
| natural convection problem for a CHT problem | Se-Hee | CFX | 2 | June 10, 2007 07:29 |
| Adiabatic and Rotating wall (Convection problem) | ParodDav | CFX | 5 | April 29, 2007 20:13 |
| Is this problem well posed? | Thomas P. Abraham | Main CFD Forum | 5 | September 8, 1999 15:52 |
Linear Mode
