Need suggestion about simulation of plasma induced flow

mukut · September 24, 2010, 23:28

[Where is my previous post in this MAIN CFD FORUM. Is it deleted by ADMIN? Did I make any violation in this forum? I am confused]

By using PHOENICS I want to make flow simulation. The solution domain like as follows--

I set some boundary conditions and by PRPS I set AIR and DIELECTRIC MATERAIL (GRAY) as upper and lower domain.

How can I set permittivity? One of my post Mr. Richard said that it could be set by PRNDTL(EPOT).

I also read about it on: http://www.cham.co.uk/phoenics/d_pol...enc_e.htm#epot

But I am not clear, help me please

mukut · October 6, 2010, 21:45

Till now no suggestion from any member. Please provide some suggestion and advice.... If we don't co-operate with each other then it is so hard for the beginner to keep in track. Hope you all provide some information/suggestion/guidance to go further.

Actually without sharing experience, only reading manual and practicing the software can't be fruitful.

mostafa kamal · July 28, 2020, 15:21

ok man you can use setfields utility if you are using openfoam which sets different values for this field in different zones
i don't know in fluent what to do

September 24, 2010, 23:28	Need suggestion about simulation of plasma induced flow	#1
mukut Senior Member Mominul MuKuT Join Date: Mar 2009 Location: Bangladesh Posts: 124 Rep Power: 17	*[Where is my previous post in this MAIN CFD FORUM. Is it deleted by ADMIN? Did I make any violation in this forum? I am confused]* By using PHOENICS I want to make flow simulation. The solution domain like as follows-- I set some boundary conditions and by PRPS I set AIR and DIELECTRIC MATERAIL (GRAY) as upper and lower domain. How can I set permittivity? One of my post Mr. Richard said that it could be set by PRNDTL(EPOT). I also read about it on: http://www.cham.co.uk/phoenics/d_pol...enc_e.htm#epot But I am not clear, help me please Last edited by mukut; September 24, 2010 at 23:58.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
how to set up high temperature gas turbine flow simulation?	adam2008	CFX	1	July 22, 2009 19:33
Expert parameter to stop the fluid flow simulation	KK	CFX	1	February 25, 2008 17:29
Nozzle Flow Simulation	Winnie	CFX	0	August 24, 2007 11:10
Internal flow simulation boundary conditions	Kishore	FLUENT	1	July 10, 2007 12:42
Transient Simulation for pipe flow	Sam	CFX	0	January 7, 2005 01:06

October 6, 2010, 21:45		#2
mukut Senior Member Mominul MuKuT Join Date: Mar 2009 Location: Bangladesh Posts: 124 Rep Power: 17	Till now no suggestion from any member. Please provide some suggestion and advice.... If we don't co-operate with each other then it is so hard for the beginner to keep in track. Hope you all provide some information/suggestion/guidance to go further. Actually without sharing experience, only reading manual and practicing the software can't be fruitful.

July 28, 2020, 15:21		#3
mostafa kamal New Member mostafa kamal Join Date: Jun 2019 Posts: 16 Rep Power: 7	ok man you can use setfields utility if you are using openfoam which sets different values for this field in different zones i don't know in fluent what to do