models for CFD analysis

Marteusz · May 16, 2009, 15:20

Hi,
I am new here, so Hello to everyone.

I am student and I am working on my MA thesis. I am writing here to get some models. Can anyone recommend me website with 3d cad models of ball, throttle, flow, pressure valves, cylinders and another elements used in automatic, that are worth to analyze in CFX. I have checked festo, bosch rexroth websites, but they offer only models without internal paths. I be very grateful for your help.

Mateusz K.

Maddin · May 18, 2009, 05:20

I think the problem are the "rights" on their products, because of this rights they don't will give you any data's/details.
I think you can to buy the products and to cut them and make your own modell.

I think you should make this for 3-4 units and then you have enough "data's" to write your MA because you must validate your calculations...

May 16, 2009, 15:20	models for CFD analysis	#1
Marteusz New Member Join Date: May 2009 Posts: 10 Rep Power: 17	Hi, I am new here, so Hello to everyone. I am student and I am working on my MA thesis. I am writing here to get some models. Can anyone recommend me website with 3d cad models of ball, throttle, flow, pressure valves, cylinders and another elements used in automatic, that are worth to analyze in CFX. I have checked festo, bosch rexroth websites, but they offer only models without internal paths. I be very grateful for your help. Mateusz K.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Two-fluid models vs mixture models for bubbly flows	Hansong Tang	Main CFD Forum	6	December 8, 2009 04:21
Stability Analysis of OpenFoam twofluid models	pierre	OpenFOAM Running, Solving & CFD	1	March 14, 2007 09:13
Two different fluid models in same analysis	rajinikanth	CFX	2	February 19, 2007 18:19
Short Course: Computational Thermal Analysis	Dean S. Schrage	Main CFD Forum	11	September 27, 2000 18:46
Is CFD Science or Art ?	John C. Chien	Main CFD Forum	36	October 5, 1999 13:58

May 18, 2009, 05:20		#2
Maddin Senior Member Join Date: Mar 2009 Posts: 260 Rep Power: 18	I think the problem are the "rights" on their products, because of this rights they don't will give you any data's/details. I think you can to buy the products and to cut them and make your own modell. I think you should make this for 3-4 units and then you have enough "data's" to write your MA because you must validate your calculations...