|
[Sponsors] |
![]() |
![]() |
#1 |
Guest
Posts: n/a
|
Hi,
I am working on a multi-fluid flowing (no mixing)inside a channel project. Can anyone point a direction and/or references that show how the wall contact angle is implemented? Thanks! schou |
|
![]() |
![]() |
![]() |
#2 |
Guest
Posts: n/a
|
You need to select wall adhesion in Phases Interaction. Then in Boundary conditions, you select wall, set its momentum property, you will see a place to set contact angle. good luck
|
|
![]() |
![]() |
![]() |
#3 |
Guest
Posts: n/a
|
Thanks for the response.
But, I am not looking for the steps how to specify contact angle. I am looking for the procedures/algorithm to "code" contact angle in a fortran source code. In other words, how to implement the contact angle function in the source code. |
|
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Commercial meshers] tmerge utility creates unwanted interface/walls comes in the final mesh | Shoonya | OpenFOAM Meshing & Mesh Conversion | 11 | January 20, 2012 06:23 |
[Netgen] Import netgen mesh to OpenFOAM | hsieh | OpenFOAM Meshing & Mesh Conversion | 32 | September 13, 2011 05:50 |
Contact Angle | ata | OpenFOAM | 6 | May 26, 2010 00:30 |
Theoretical background of formula for dynamic contact angle in interfoam | sebastian_vogl | OpenFOAM Running, Solving & CFD | 3 | June 22, 2009 12:25 |
problems with UDF to set contact angle | poiuy219 | Main CFD Forum | 0 | April 30, 2009 10:43 |