|
[Sponsors] |
The torque values keep increasing in ANSYS Fluent. |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
July 26, 2024, 17:00 |
The torque values keep increasing in ANSYS Fluent.
|
#1 |
New Member
nelson Olatunji
Join Date: Jul 2024
Posts: 2
Rep Power: 0 |
Dear Researcher,
I am currently experiencing a problem in a project I am working on. I am working on wind turbines and trying to determine the power coefficient close to the one in an experimental study. However, I keep having issues with the torque. I observe that the torque keeps increasing in ANSYS Fluent after the 3rd cycle. I was trying to run the case for 6-8 cycles, but the values keep increasing immediately after the 3rd-4th cycle. I need a hint on how to make it converge perfectly without increasing after the 3rd cycle. Kindly help if you have any idea on how I can solve these problems. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Ansys Fluent v232 crash on starting | OmarZaki | FLUENT | 8 | July 31, 2024 04:16 |
How to define a hole as boundary condition in Ansys Fluent using Fluent an mesh only? | Nagu Sattenapalli | CFD-Wiki | 0 | August 12, 2019 04:03 |
Ansys SIG$ILL error | loth | ANSYS | 3 | December 24, 2015 05:31 |
2-way FSI in Ansys CFX 15 | LucasGasparino | CFX | 3 | August 6, 2015 03:17 |
The fluent stopped and errors with "Emergency: received SIGHUP signal" | yuyuxuan | FLUENT | 0 | December 3, 2013 22:56 |