Using simflow to test a go kart inlet -- CFD Online Discussion Forums

August 25, 2021, 10:55	Using simflow to test a go kart inlet	#1
Ravihotwok New Member flintshire Join Date: Aug 2021 Posts: 1 Rep Power: 0	Hello everyone im very new to this so please go easy. I have modelled a intake inlet for my gokart and would like to flow test it using simflow. Is this possible? I have downloaded simflow and inserted the geometry from a stl fine but thats where the process stops as im completely clueless. Any help would be most appreciated

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[OLAFLOW] The OLAFLOW Thread	Phicau	OpenFOAM Community Contributions	459	September 12, 2024 12:47
Problem with velocity inlet using FireFoam	Jean_S	OpenFOAM	0	July 5, 2021 05:40
Looping over all faces within a boundary condition (turbulent inlet development)	Sevex	OpenFOAM Programming & Development	5	September 8, 2016 14:58
How to set up the inlet boundary condition for a low pressure case?	beastieboys6	FLUENT	3	April 10, 2012 23:46
OF 1.6 \| Ubuntu 9.10 (64bit) \| GLIBCXX_3.4.11 not found	piprus	OpenFOAM Installation	22	February 25, 2010 14:43

All times are GMT -4. The time now is 23:42.