Warning: Can't recover edge near position

mazhar16823 · June 27, 2020, 11:21

Hi,

I used Surface Remesher+Polyhedral+Prism Layer Mesher, it did not give me any error. But as my blade contains curved edges the mesh quality was not good so I switched to Surface+Polyhedral+Advanced Layer Mesher which gives me a warning:

can't recover edge near position: ( 1.18032e+00, 2.80673e+01, -3.58532e-01)
switched to non-conformal method!
refining surface...
can't recover edge near position: ( 1.18032e+00, 2.80673e+01, -3.58532e-01)

The mesher is not proceeding beyond this stage due to this warning. Any idea how to eliminate it?

Thanks for your time.

Best regards,

JBeilke · June 28, 2020, 16:36

Guide: How to ask a question on the forums

There is a dedicated subforum for CCM+.

June 27, 2020, 11:21	Warning: Can't recover edge near position	#1
mazhar16823 Senior Member MA Join Date: Mar 2020 Posts: 163 Rep Power: 6	Hi, I used Surface Remesher+Polyhedral+Prism Layer Mesher, it did not give me any error. But as my blade contains curved edges the mesh quality was not good so I switched to Surface+Polyhedral+Advanced Layer Mesher which gives me a warning: can't recover edge near position: ( 1.18032e+00, 2.80673e+01, -3.58532e-01) switched to non-conformal method! refining surface... can't recover edge near position: ( 1.18032e+00, 2.80673e+01, -3.58532e-01) The mesher is not proceeding beyond this stage due to this warning. Any idea how to eliminate it? Thanks for your time. Best regards,

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[mesh manipulation] RefineMesh Error and Foam warning	jiahui_93	OpenFOAM Meshing & Mesh Conversion	4	March 3, 2018 12:32
[mesh manipulation] refineMesh Error	mohsen.boojari	OpenFOAM Meshing & Mesh Conversion	3	March 1, 2018 23:07
using METIS functions in fortran	dokeun	Main CFD Forum	7	January 29, 2013 05:06
OpenFOAM Solaris	mamaly60	OpenFOAM Installation	13	May 10, 2010 22:16
fluent add additional zones for the mesh file	SSL	FLUENT	2	January 26, 2008 12:55

June 28, 2020, 16:36		#2
JBeilke Senior Member Joern Beilke Join Date: Mar 2009 Location: Dresden Posts: 521 Rep Power: 20	Guide: How to ask a question on the forums There is a dedicated subforum for CCM+.