 |
 |
 |
|
|
|
[Sponsors] | ||||
June 19, 2020, 09:03
|
Maximum Skewness Angle
|
#1 |
|
Senior Member
MA
Join Date: Mar 2020
Posts: 163
Rep Power: 6  |
Hi everyone,
I have generated a coarse mesh away from the geometry and refined mesh on itself. But I see that the maximum skewness angle is greater than 85 degrees so I reduced and increased the base size by some orders but it is not changing the maximum skewness angle. Could you please suggest how to reduce it? Thanks for your time. |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [ANSYS Meshing] Difference between average skewness and maximum skewness | ParasuRam | ANSYS Meshing & Geometry | 4 | February 15, 2018 07:22 |
| compressible flow in turbocharger | riesotto | OpenFOAM | 50 | May 26, 2014 02:47 |
| [Netgen] Import netgen mesh to OpenFOAM | hsieh | OpenFOAM Meshing & Mesh Conversion | 32 | September 13, 2011 06:50 |
| Maximum Cell Skewness | killtimm | FLUENT | 0 | June 27, 2010 08:34 |
| Severe nonorthogonality and severe skewness problem | qtian | OpenFOAM Running, Solving & CFD | 2 | January 22, 2008 19:47 |
Linear Mode
