Relation between shear stress and bed level

pouy@ · August 20, 2018, 18:06

Hello all,
The photo below contains two photos of shearing stress and bed level from a bridge pier model in the ssiim.
Will you help me in the shear stress analysis of this photo?
Except where the maximum shear stress is maximum scour should happen?
Why does not this photo show this?
This is the case in all ssiim models and I'm sure the answer is correct.
Thanks

Saeed.Rad · September 17, 2018, 09:16

There are cases in which the shear stress pattern is not consistent with the scour geometry. In cases like these, the turbulent kinetic energy is sometimes useful. When modeling with SSIIM, the modeler should definitely take into consideration the height of the bed cell and roughness.

August 20, 2018, 18:06	Relation between shear stress and bed level	#1
pouy@ New Member pouya Join Date: Jun 2017 Posts: 11 Rep Power: 9	Hello all, The photo below contains two photos of shearing stress and bed level from a bridge pier model in the ssiim. Will you help me in the shear stress analysis of this photo? Except where the maximum shear stress is maximum scour should happen? Why does not this photo show this? This is the case in all ssiim models and I'm sure the answer is correct. Thanks

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Bed shear stress	mahdi1	FLOW-3D	0	May 28, 2015 15:46
shear stress	amirhesam	FLOW-3D	0	April 6, 2015 14:13
DEFINE_GRID_MOTION with calculation of wall shear stress	Entwistle	Fluent UDF and Scheme Programming	1	July 10, 2014 04:12
wall shear stress in bed channel	pedroxramos	FLUENT	0	January 11, 2013 20:44
excess shear stress in Flow3D	ETHACuch1	FLOW-3D	1	January 14, 2011 16:52

September 17, 2018, 09:16		#2
Saeed.Rad New Member Saeed Kamrani Rad Join Date: Jul 2017 Posts: 4 Rep Power: 9	There are cases in which the shear stress pattern is not consistent with the scour geometry. In cases like these, the turbulent kinetic energy is sometimes useful. When modeling with SSIIM, the modeler should definitely take into consideration the height of the bed cell and roughness.