 |
 |
 |
|
|
|
[Sponsors] | ||||
February 25, 2018, 04:44
|
Transient species transport case
|
#1 |
|
New Member
Join Date: Oct 2017
Posts: 23
Rep Power: 9  |
Hello guys, currently i am doing a simulation by using species transport...however, i have found that if i change the setting from steady to transient model, the concentration of one of the species at the outlet became relatively small (10^-250)...i was wondering is it species transport model cannot be applied in transient case? The settings of my case is shown as below:
Inlet 1: fluid A Inlet 2: fluid B (Bulk species) Output results (mass fraction of A) at the outlet: Steady case: 0.5-0.6 Transient case: 0 |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [DesignModeler] DesignModeler Scripting: How to get Full Command Access | ANT | ANSYS Meshing & Geometry | 53 | February 16, 2020 16:13 |
| Species Transport: How to determine the mass flux from concentration gradients? | Zaphod'sSecondHead | FLUENT | 2 | January 9, 2016 09:16 |
| questions about species transport through walls | shuqin | FLUENT | 13 | April 9, 2014 03:42 |
| Implement species transport equation | Tobi | OpenFOAM Programming & Development | 0 | June 2, 2012 14:26 |
| Species Transport with multiphase flow | Gopal Kasat | FLUENT | 3 | July 12, 2005 19:59 |
Linear Mode
