Alignment Problem in CFX Pre -- CFD Online Discussion Forums

February 27, 2016, 13:39

Alignment Problem in CFX Pre

st7rocks

New Member

siva teja

Join Date: Feb 2016

Posts: 1

Rep Power: 0

hi,
I have been working with centrifugal pumps for a while and i am facing a problem in aligning the impeller and volute in ANSYS CFX Pre.

i've designed the impeller using bladegen and meshed it using turbogrid.
At same time i created a volute casing in solid works imported the geometry into ansys, meshed it using ICEM CFD...

and this is what i get in CFX pre..

can someone help me how to proceed with this...

thanks in advance..

Attached Images

	1.jpg (69.1 KB, 8 views)
	2.jpg (97.3 KB, 8 views)
	3.jpg (111.6 KB, 8 views)
	4.jpg (72.2 KB, 8 views)

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[ICEM] issue occur after extrude 2D airfoil mesh and convergence problem in CFX	shiyun	ANSYS Meshing & Geometry	4	May 9, 2012 20:55
about Taylor-Green Vortex problem in CFX	cuteapathy	CFX	4	March 26, 2012 07:44
CFX pressure in Simulations problem	nasdak	CFX	1	April 14, 2010 14:22
cfx mesh problem...	mactech001	ANSYS Meshing & Geometry	0	November 5, 2009 03:19
CFX 4.4 installation problem	Pandu Sattvika	CFX	1	December 1, 2001 05:07

All times are GMT -4. The time now is 08:12.