|
[Sponsors] |
March 11, 2009, 11:57 |
VTK to FOAM?
|
#1 |
Guest
Posts: n/a
|
Hello everyone!
Since I'm dealing with a slightly more complex geometry and it would be a killer to do it directly from OpenFOAM's mesh designer, I would like to know is there a simple converter for ANY of the following: .vtk to OpenFOAM .prt to OpenFOAM (ProEngineer to OpenFOAM) .stl to OpenFOAM .pvd to OpenFOAM I need to transfer my geometry into OpenFOAM pre-processing format so I could set the boundary conditions and generate the mesh. Thank a lot! |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Commercial meshers] Using starToFoam | clo | OpenFOAM Meshing & Mesh Conversion | 33 | September 26, 2012 05:04 |
[blockMesh] BlockMesh FOAM warning | gaottino | OpenFOAM Meshing & Mesh Conversion | 7 | July 19, 2010 15:11 |
[Gmsh] Import problem | ARC | OpenFOAM Meshing & Mesh Conversion | 0 | February 27, 2010 11:56 |
[blockMesh] Axisymmetrical mesh | Rasmus Gjesing (Gjesing) | OpenFOAM Meshing & Mesh Conversion | 10 | April 2, 2007 15:00 |
[Gmsh] Import gmsh msh to Foam | adorean | OpenFOAM Meshing & Mesh Conversion | 24 | April 27, 2005 09:19 |