water and air interface boundary

September 8, 2008, 17:11

Hi..I am trying to find drag coefficient on a object partially immersed in water using Fluent. I used GAMBIT for modeling and meshing. I am not sure about about defining the boundary type of water surface. Could someone help me in this regard, please?

September 9, 2008, 16:55

at free surface the pressure could be set equal to atmospheric pressure

September 25, 2008, 10:11

CAN HELP ME I NEED TO MODEL WATER SURFAC OR WATER LEVEL TO MODEL TO PHASE FLOW WATER AIR THROGTH POROUS MEDIA OR INTERFACE BETWEEN WATER AND AIR PLESAS

September 8, 2008, 17:11	water and air interface boundary	#1
Shivakanth Guest Posts: n/a	Hi..I am trying to find drag coefficient on a object partially immersed in water using Fluent. I used GAMBIT for modeling and meshing. I am not sure about about defining the boundary type of water surface. Could someone help me in this regard, please?

September 9, 2008, 16:55	Re: water and air interface boundary	#2
MAB Guest Posts: n/a	at free surface the pressure could be set equal to atmospheric pressure

September 25, 2008, 10:11	Re: water and air interface boundary+GAMIT FLUENT	#3
AODAY_ALTURRFY Guest Posts: n/a	CAN HELP ME I NEED TO MODEL WATER SURFAC OR WATER LEVEL TO MODEL TO PHASE FLOW WATER AIR THROGTH POROUS MEDIA OR INTERFACE BETWEEN WATER AND AIR PLESAS

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
mass flow in is not equal to mass flow out	saii	CFX	12	March 19, 2018 06:21
(interfoam) shear stress at water air interface !	openfoam1	OpenFOAM	11	October 27, 2014 04:59
CFX doesn't continue calculation...	mactech001	CFX	6	November 15, 2009 22:25
air bubble is disappear increasing time using vof	xujjun	CFX	9	June 9, 2009 08:59
Concentric tube heat exchanger (Air-Water)	Young	CFX	5	October 7, 2008 00:17