 |
 |
 |
|
|
|
[Sponsors] | ||||
May 15, 2008, 18:05
|
Tetra vs Hexa meshing for a wing
|
#1 |
|
Guest
Posts: n/a
|
Hello again,
On the same project I'd like to mesh a wing in a wind tunnel. What kind of meshing should I use, structured or unstructured. If I use the structured one, the blocking can take longer time. Thanks !! |
|
|
||
|
May 22, 2008, 05:55
|
Re: Tetra vs Hexa meshing for a wing
|
#2 |
|
Guest
Posts: n/a
|
try n use hex structured mesh only.
|
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [ICEM] Hexa meshing of impeller and diffuser assembly | Nitin Dewangan | ANSYS Meshing & Geometry | 14 | September 13, 2016 10:41 |
| Wing Meshing | steve1 | ANSYS Meshing & Geometry | 1 | July 5, 2011 10:14 |
| Hexa + Tetra meshing (Hybrid) in ICEM | vmlxb6 | ANSYS Meshing & Geometry | 12 | December 27, 2010 11:18 |
| 3D wing + wind tunnel hexa structured meshing | icemaniac178 | ANSYS Meshing & Geometry | 9 | October 28, 2010 10:37 |
| Hexa meshing or Tetra meshing??? | NITIN DEWANGAN | CFX | 5 | August 5, 2008 10:59 |
Linear Mode
