 |
 |
 |
|
|
|
[Sponsors] | ||||
January 17, 2008, 22:01
|
top
|
#1 |
|
Guest
Posts: n/a
|
Sorry if this is too basic. When we use "top" command on linux or unix server, can someone tell me what do the labels for each column mean?
PR = ? NI = ? VIRT = ? RES = this is the actual memory being used, correct? SHR = ? |
|
|
||
|
January 18, 2008, 10:07
|
Re: top
|
#2 |
|
Guest
Posts: n/a
|
If you type in "man top" to bring the manual page up for the top command then all your questions should be answered. If the manual pages have not been installed then you need to go to your system administrator and get them installed.
|
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| separating top surfaces after extruding the 2D mesh | Mario-CFD | ANSYS Meshing & Geometry | 3 | January 8, 2011 16:26 |
| about the top of the mixing tank | boh_tea | FLUENT | 7 | August 21, 2010 04:58 |
| Averaged Value Profile From bottom to top in duct | Hang Gi Lee | CFX | 0 | February 5, 2007 09:06 |
| Top boundary in a entrainment atmospheric BL | Reginaldo Paula | FLUENT | 0 | May 9, 2006 17:38 |
| Top Top Urgent!!! | Mohammed Shamol | Main CFD Forum | 1 | May 26, 2004 04:40 |
Linear Mode
