 |
 |
 |
|
|
|
[Sponsors] | ||||
January 10, 2008, 02:41
|
Incomplete NACA 0012 profile
|
#1 |
|
Guest
Posts: n/a
|
Hi, i transferred the the NACA 0012 ordinates onto my CFD code and realised that the profile is incomplete. This meaning that at x=1, y is not equal to 0. what should i do to solve this problem?
Cheerios Rif |
|
|
||
|
January 10, 2008, 03:45
|
Re: Incomplete NACA 0012 profile
|
#2 |
|
Guest
Posts: n/a
|
This is a well-known drawback of NACA 0012. You may close the contour by setting the trailing edge, e.g., at x=1.008 , y=0 .
|
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [swak4Foam] GroovyBC the dynamic cousin of funkySetFields that lives on the suburb of the mesh | gschaider | OpenFOAM Community Contributions | 300 | October 29, 2014 19:00 |
| How to import NACA 0012 Profile in Gridgen | maplepink | Main CFD Forum | 17 | May 7, 2013 14:01 |
| NACA 0012 Case Will Not Converge | dancfd | OpenFOAM Running, Solving & CFD | 6 | November 14, 2011 20:09 |
| NACA 0012 simulation results | Luis | FLUENT | 3 | February 15, 2006 12:42 |
| bladegen & NACA profile | ichgut | CFX | 1 | August 9, 2004 10:31 |
Linear Mode
