Mesh motion updating issue -- CFD Online Discussion Forums

November 15, 2014, 11:12	Mesh motion updating issue	#1
diablo47 New Member Saurabh Kumar Join Date: Nov 2014 Posts: 1 Rep Power: 0	Hi all, I am using a transient sliding mesh model to model a torque converter.. The model runs and converges fine on every time step. But after a few time-steps (79 in this case), the next step just can't load.. the message in TUI is Updating solution at time level N... done. and it's just stuck after that. Any suggestions?

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[snappyHexMesh] No layers in a small gap	bobburnquist	OpenFOAM Meshing & Mesh Conversion	6	August 26, 2015 10:38
[ICEM] Generating Mesh for STL Car in Windtunnel Simulation	tommymoose	ANSYS Meshing & Geometry	48	April 15, 2013 05:24
Prescribed mesh motion does not correspond to actual motion	rbarrett	CFX	8	June 30, 2011 14:22
Discrete Values for Mesh Motion	UnderwaterAlex	CFX	2	February 21, 2008 19:21
large scale mesh motion	sb	FLUENT	1	April 27, 2007 23:23

All times are GMT -4. The time now is 13:18.