|
[Sponsors] |
![]() |
![]() |
#1 |
Guest
Posts: n/a
|
Hello,
Does anybody know how to use CFX tools such as Meshbuild, Meshimport to generate a mesh from a log-file etc. without opening the interactive part of the program (this of course applies only to Meshbuild), or can I create a mesh within curved boundaries in the userroutines (including GP) Regards Oliver |
|
![]() |
![]() |
![]() |
#2 |
Guest
Posts: n/a
|
Hi Oliver,
You can run Meshbuild and Meshimport from the command line using "runmb" and "runmi". There is an option to load in a configuration file into Meshimport from the command line - see p106 of the CFX 4.2 Environment manual. If you are using CFX-Build to generate your geometry you can run it in batch mode (ie no GUI) using the "-b" option and specifying a session file to play. Refer to the same page of the manual for this. Alternatively, you can not use the pre-processors at all. If you have a very simple geometry you can specify it using the >>MODEL TOPOLOGY, and >>CREATE GRID commands in the command file. More complicated grids can be specified using the user fortran routines USRGRD and USRTPL. Cheers, Glenn Horrocks |
|
![]() |
![]() |
![]() |
#3 |
Guest
Posts: n/a
|
Hi Glenn,
Thanks for your responce. I would love to use Meshbuild to create a geometry file from a log-file which is 'altered' externally. I cannot see how to obtain a geometry file from a log file just by using command line options without pressing any buttons, just like in CFX-build. Could you point me in a direction how to achieve this? Regards Oliver |
|
![]() |
![]() |
![]() |
#4 |
Guest
Posts: n/a
|
Hi Oliver,
I don't think Meshbuild has an equivalent of the batch mode in CFX-Build. Try opening a log file in a text editor and seeing if you can work out the format - that will minimise the clicking you have to do in Meshbuild. Cheers, Glenn |
|
![]() |
![]() |
![]() |
#5 |
Guest
Posts: n/a
|
Hello Glenn,
My problem is that I don't want to have any clicking at all. Well, I suppose I have to use BUILD. Thanks and Regards Oliver |
|
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Automatic wall treatment in CFX | Chander | CFX | 13 | May 6, 2017 01:45 |
Pros and Cons for CFX, CFdesign, COMSOL | Val | Main CFD Forum | 3 | June 10, 2011 03:20 |
CFX doesn't continue calculation... | mactech001 | CFX | 6 | November 15, 2009 22:25 |
PhD using CFX | Rui | CFX | 9 | May 28, 2007 06:59 |
CFX 4.4 installation problem | Pandu Sattvika | CFX | 1 | December 1, 2001 05:07 |