 |
 |
 |
|
|
|
[Sponsors] | ||||
September 22, 2007, 12:23
|
Trying to have EasyCFD on the News section
|
#1 |
|
Guest
Posts: n/a
|
Hello! I am trying to have the educational software EasyCFD release (www.easycfd.net) in the News section of this site. I submitted on the 17 September (other news were posted after that..), then I sent an email to the administrator (webmaster@cfd-online.com), but never got any answer. I already had an email sent 1 month ago trying to have the software listed in the site, but never got any answer. Am I missing something? Suggestions? Apart from that, I must say the site is great for the CFD community.
|
|
|
||
|
September 22, 2007, 12:43
|
Re: Trying to have EasyCFD on the News section
|
#2 |
|
Guest
Posts: n/a
|
Your news submission title was written in all low-caps so we incorrectly mixed it up with normal spam. We get something like 100 spam messages every day in the news section so it is easy to make these misstakes. Your submission is online now though. We are sorry about the delay.
|
|
|
|
||
|
September 22, 2007, 12:50
|
Re: Trying to have EasyCFD on the News section
|
#3 |
|
Guest
Posts: n/a
|
Thanks!
|
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [CGNS] CGNS converters available | mbeaudoin | OpenFOAM Meshing & Mesh Conversion | 137 | December 14, 2018 05:20 |
| dsmcInitialise - dsmcFoam | archymedes | OpenFOAM Pre-Processing | 94 | July 15, 2016 17:14 |
| [Other] cgnsToFoam problems with "QUAD_4" cells | lentschi | OpenFOAM Meshing & Mesh Conversion | 1 | March 9, 2011 05:49 |
| LiftDrag utility from v12 to v141 | cfdphil | OpenFOAM Running, Solving & CFD | 2 | December 5, 2007 06:49 |
| New section and new gateways | Ynot | CFD-Wiki | 7 | December 17, 2005 14:21 |
Linear Mode
