[jatin]

I am doing flow simulation with the assembly of 4-5 parts.
Assembly has been drawn in CREO-PTC s/w.
I have drawn the maximum geometries with the center appears in the CREO part-modelling tool.
But after importing that assembly in Fluent Design-modeller, the Global coordinate system (GCS) is at the center of the front view of Assembly (where It was in CREO).

Actually I want the SYMMETRY of the complete assembly (as it vary complex), but not getting the GCS at the required position.
I had tried by drawing a Plane in the Design-modeller (at the center position), But SYMMETRY command is not working with that plane.

plz suggest a solution

Thanks